KKS® ULTRAD 630 is a highly effective superplasticizer with a set retarding effect for producing flow-able concrete in hot climate and also a substantial water reducing agent for promoting ultimate strength.
KKS® ULTRAD 630 complies with ASTM C494 type D & G.
KKS® ULTRAD 630 combines all different impacts through absorbed process on the surface of fine particles and keep it apart from each other in cement hydration processing:
• Substantial improvement in workability without increased water.
• Significantly reduce the amount of cement used but still reach grade designed concrete strength.
• Long lasting slump retention.
• High flow-ability (considerably reduced placing and compacting work).
• Easy pump, no water separation.
• Faster evolution of early strength development.
• Improved creep resistance and shrinkage resistance characteristics.
KKS® ULTRAD 630 is chloride free and other corrosive substances. Therefore it can be used in most of the reinforced and pre-stressed concrete structures.
KKS® ULTRAD 630 is used especially for concrete that needs long lasting slump retention under hot climate condition e.g.:
• Mass concrete pouring.
• Precast concrete.
• Transport concrete away.
• Climbed pump concrete.
• Structures such as foundations, floors, walls, beams, columns.
• Slender components with dense reinforcement.
• Dosage: 0.6 – 1.8 liters/ 100 kg of cement.
• Typical dosage: 0.8 – 1.2 liters/ 100 kg of cement.
KKS® ULTRAD 630 is possible to combine with all KKS’s concrete admixture products, but it must be added separately to the mix. KKS® ULTRAD 630 is compatible with all Portland cement including sulfate resistant cement.
KKS® ULTRAD 630 is added to the gauging water prior to its addition to the dry mix or added separately to the wetted concrete mix.
For optimum utilization of the ultra-high range water reducer we recommend a minimum wet mixing time of 2-3 minutes.
When adding the balance of the batching water to adjust concrete consistency this should be done after a minimum of 2/3 of the wet mixing time to avoid surplus water in the concrete.
PLACING OF CONCRETE
With the use of KKS® ULTRAD 630, concrete of highest quality is being produced, it should be complied and applied with standard procedures, such as mixing, placing vibrating and curing must be respected and applied.
APPLICATION CONDITIONS/ LIMITATIONS
Overdosing will result in increased workability and setting time of the concrete; however, provided that curing is effective, ultimate concrete strength and properties will not be affected.
Use an appropriate concrete mixer and do not mix by hand.
Trials mixes are recommended to establish exact dosage rates required to suit individual requirements. Please contact KKS Technical Department for further assistance.
Effective measures for concrete curing must be followed.
PRODUCT AND TECHNICAL DATA
Organic addictive mixture
200 liters per barrel or 1000 liters per tank
1.130 – 1.150 kg/liter
STRORAGE / SHELF LIFE
KKS® ULTRAD 630 has to be stored in dry, cool, shaded place. If stored properly in unopened, original packaging, its shelf life is 12 months.
KKS® ULTRAD 630 contains non-hazardous substances to warn. Avoid direct contact with skin. When splashed in the eyes or on skin, wash immediately with plenty of water and seek medical advice if necessary. Product is non-toxic, non-flammable and non-hazardous in transportation. Disposal should be done according to local law. For more information, please refer to the latest Product Safety Data Sheet.